Tcpdump: verbose output suppressed, use -v or -vv for full protocol decode Exception stack(0xdc489fb0 to 0xdc489ff8) (smpboot_thread_fn) from (kthread+0x188/0x1a0) (run_ksoftirqd) from (smpboot_thread_fn+0x2c0/0x2f4) (do_current_softirqs) from (run_ksoftirqd+0x30/0x54) (run_timer_softirq) from (do_current_softirqs+0x198/0x268) (expire_timers) from (run_timer_softirq+0xbc/0x25c) (dev_watchdog) from (expire_timers+0x50/0x164) (dump_backtrace) from (show_stack+0x18/0x1c) Hardware name: Generic AM43 (Flattened Device Tree) Modules linked in: cfg80211 bnep iptable_filter iptable_mangle iptable_nat nf_nat_ipv le_mangle ip6table_nat nf_nat_ipv6 nf_nat nf_conntrack libcrc32c nf_defrag_ipv4 nf_defrag_ipv6 ip6_t bg ecdh_generic cdc_ether usbnet pru_rproc irq_pruss_intc pruss ti_am335x_adc sha512_generic sha512_ ecb hmac omap_des pvrsrvkm(O) omap_aes_driver md5 des_generic crypto_engine pruss_soc_bus omap_sham c_ts wkup_m3_ipc omap_wdt rtc_omap wkup_m3_rproc remoteproc ti_am335x_tscadc mstp_cmnet(O) NETDEV WATCHDOG: eth0 (cpsw): transmit queue 0 timed out WARNING: CPU: 0 PID: 10 at net/sched/sch_generic.c:466 dev_watchdog+0x260/0x280 #Oneboard pci driver#I am seeing ethernet driver getting crashed when two prototype boards are not connected directly with ethernet cable. These pieces of information depend on UEFI.Other Parts Discussed in Thread: DP83620, AM4372 The slot information collected by DSA depends on the information Group, Bus, Device and Function Number in System Management Basic Input/Output System (SMBIOS) 2.5 type 11. DSA has fixed this issue in Fourth Quarter 2011. #Oneboard pci update#Note: This fix is dependent on an update to Unified Extensible Firmware Interface (UEFI). The file is or will be available by selecting the appropriate machine type on the 'Product View' of IBM Support's Fix Central web page, at the following URL: This behavior has been corrected in DSA 4.00 (Build ID: DSYT91SUS). Please see the compatibility page for more information: Solution Note: This does not imply that the network operating system will work under all combinations of hardware and software. The following system firmware level(s) are affected: The following system BIOS or UEFI level(s) are affected:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |